Reference: RPICT3V1_XVFI
RPIZ_CT3T1 - 3 CT and 1 Temperature AC adaptor for Raspberrypi zero.
Rating: Choose the maximum rms current in Ampere the board can support with the associated CT. For any custom setup please opt for "other".
Sensors and Raspberrypi are not included.
Microcontroler | Atmel Attiny84 |
MCU Frequency | 8Mhz |
Operating Voltage | 3.3V |
Waveform Sampling | 2500sps |
Fastest Data Polling | 600ms |
Vertical Resolution | 10 bits (1024 steps) |
Communication | UART Serial Port |
Firmware | Arduino (open source) |
Dimensions | 56x35mm |
Programming port | 6 pin ISP |
Compatible OS | Any supporting GPIO serial port access |
Compatible Raspberrypi | All of Family Raspebrrypi Zero |
Compatible CT | Current output type |
AC Current Range | Options from 20A to 600A |
Max Temperature probes | 8 |
Smallest Readable Current | Approx 50mA to 150mA |
This development board/kit is intended for use for ENGINEERING DEVELOPMENT, DEMONSTRATION, OR EVALUATION PURPOSES ONLY and is not considered by LeChacal.com to be a finished end-product fit for general consumer use. Persons handling the product(s) must have electronics training and observe good engineering practice standards. As such, the goods being provided are not intended to be complete in terms of required design-, marketing-, and/or manufacturing-related protective considerations, including product safety and environmental measures typically found in end products that incorporate such semiconductor components or circuit boards. This
evaluation board/kit does not fall within the scope of the European Union directives regarding electromagnetic compatibility, restricted substances (RoHS), recycling (WEEE), FCC, CE or UL, and therefore may not meet the technical requirements of these directives or other related directives.
Reference: RPICT3V1_XVFI
Reference: RPICT8_GCFK
Reference: CTC01
Reference: 77DB-06-09
Reference: 77DE-06-09
Reference: SCT019
Reference: 77DA-10-09
Reference: UsbSwitch
Reference: SCT-006_20A/25mA
check_circle
check_circle