NanoProg - Arduino Programmer Attiny Atmega

Nanoprog - Avr Programmer - Arduino as ISP

Upload bootloader and arduino sketch to arduino compatible microcontroller.


The nano prog is a shield for the Arduino Nano board. Assembled together makes an easy to use avr programmer

Attiny85 and attiny13 chip can be directly fitted on the Nanoprog. Any other chip must be connected with the 6 pin ribbon cable via ISP.


You might have tried other programmers failing? This one will work uploading your arduino sketch. Easy to use.

Documentation

• 3 Status LED
• 1 6pin ISP port
• 1 8 pin DIL socket for attiny85 attiny13

Uses ArduinoISP sketch as firmware. Open source firmware provided by Arduino IDE itself from the file/examples menu.

Note this is the ideal unit to program all our RPICT series board (RPICT3 RPICT7V1 etc...)

Package Content

Please select one of the two options

Full Package

• 1 Nanoprog Unit.
• 1 Arduino Nano Board (ft232rl chip version)
• 1 6pin ribbon cable

Shield Only

• 1 Nanoprog Unit.

This development board/kit is intended for use for ENGINEERING DEVELOPMENT, DEMONSTRATION, OR EVALUATION PURPOSES ONLY and is not considered by LeChacal.com to be a finished end-product fit for general consumer use. Persons handling the product(s) must have electronics training and observe good engineering practice standards. As such, the goods being provided are not intended to be complete in terms of required design-, marketing-, and/or manufacturing-related protective considerations, including product safety and environmental measures typically found in end products that incorporate such semiconductor components or circuit boards. This
evaluation board/kit does not fall within the scope of the European Union directives regarding  electromagnetic compatibility, restricted substances (RoHS), recycling (WEEE), FCC, CE or UL, and therefore may not meet the technical requirements of these directives or other related directives.