RPICT7V1 Version 2 - 7 CT - 1Voltage - Stackable

New product

Raspberrypi CT Adaptor

Connect up to 7 Current and 1 voltage sensors to a raspberrypi.

Master Kit:
Include RPICT board with
* microcontroller
* 4x female female standoff 11mm
Slave Kit:
Include RPICT board with
* microcontroller excluded
* 4x male female standoff 12mm

More details

275 Items

£ 34.75

  • Master Kit
  • Slave Kit

Add to wishlist

More info



RPICT7V1 version 2- Raspberrypi SCT Adaptor


IMG_1128_small.pngConnect 7 Current and 1 voltage sensors to a Raspberrypi



Documentation


  • 7x Current sensor ports
  • 1x ac Voltage sensor ports
  • Arduino IDE programmable
  • EmonCMS compatible.
  • CSV serial output
  • Atmega328 Microcontroller
  • View/record data using Linux/Python/Emoncms
  • Stackable - Up to 5 board stack on one Raspberrypi.
  • Compatible with Raspberrypi 2 & 3.


Package Content

  • 1 RPICT7V1 version 2 Unit.
  • 4 Mounting Spacers
  • 8 Mounting Screws
Note: spacers for slave and master differs. Spacers for master board will be sent. Slave spacers can be purchased separately. See acessories at the bottom of this page.

Recommended Sensors

  • Voltage: 77DB-06-09 77DE-06-09 77DA-10-09 CT3957-NA
  • Current: SCT-013-000 Or any current output CT


Choose appropriate rating when purchasing. Default is 100A rms.

Default Configuration

Output format is Emonhub by default. Output format configurable via serial interface.

Outputs 21 channels:

  • Real Power x7 (Watts)
  • Irms x7 (mAmps)
  • Vrms x1 (Volts)
(note apparent power can be calculated using Vrms*Irms.

Parameters:

Node ID: 11
Scan interval: 5 seconds
Output: Emonhub

Default loaded sketch freely available on the wiki page.

Emoncms Ouput:


Rpict7v1_channels_001.png

Stacking boards

IMG_0980_small.png
The RPICT7V1 version2 can be stacked with other RPICT7V1 or RPICT4V3 or RPICT8 to expand the numbers of sensors supported. All units are sold configured as master. Please refer to the wiki page to learn how to configure them as slave. Stacking Documentation


Reviews

Grade 
2019-01-28

Great product, very easy to use!

Instructions are detailed, and once you figure out the few basic setup steps and terminology if you are not super familiar with electrical, it is quite easy to use. Got it work on a Pi3 and Orange Pi.

Write a review

RPICT7V1 Version 2 - 7 CT - 1Voltage - Stackable

RPICT7V1 Version 2 - 7 CT - 1Voltage - Stackable

Raspberrypi CT Adaptor

Connect up to 7 Current and 1 voltage sensors to a raspberrypi.

Master Kit:
Include RPICT board with
* microcontroller
* 4x female female standoff 11mm
Slave Kit:
Include RPICT board with
* microcontroller excluded
* 4x male female standoff 12mm

Accessories