(for any other CT sensor please contact us to have adapted resistor mounted and calibration coefficients calculated)
Technical Specifications
Microcontroler
Atmel Attiny84
MCU Frequency
8Mhz
Operating Voltage
3.3V
Waveform Sampling
2500sps
Fastest Data Polling
600ms
Vertical Resolution
10 bits (1024 steps)
Communication
UART Serial Port
Firmware
Arduino (open source)
Dimensions
56x35mm
Programming port
6 pin ISP
Compatible OS
Any supporting GPIO serial port access
Compatible Raspberrypi
All of Family Raspebrrypi Zero
Compatible CT
Current output type
AC Current Range
Options from 20A to 600A
Max Temperature probes
8
Smallest Readable Current
Approx 50mA to 150mA
Scope of Use
This development board/kit is intended for use for ENGINEERING DEVELOPMENT, DEMONSTRATION, OR EVALUATION PURPOSES ONLY and is not considered by LeChacal.com to be a finished end-product fit for general consumer use. Persons handling the product(s) must have electronics training and observe good engineering practice standards. As such, the goods being provided are not intended to be complete in terms of required design-, marketing-, and/or manufacturing-related protective considerations, including product safety and environmental measures typically found in end products that incorporate such semiconductor components or circuit boards. This evaluation board/kit does not fall within the scope of the European Union directives regarding electromagnetic compatibility, restricted substances (RoHS), recycling (WEEE), FCC, CE or UL, and therefore may not meet the technical requirements of these directives or other related directives.
Connect up to 8 Current sensors to a Raspberrypi.
This is the slave version of the RPICT8 this can only work with a master RPICT board version 6 such as RPICT8 or RPICT7V1 or RPICT4V3.
Package includes slave stand off for mounting onto master board.
Connect up to 4 Current sensors and 3 Voltage sensors to a Raspberrypi.
This is the slave version of the RPICT4V3 this can only work with a master RPICT board version 5 such as RPICT8 or RPICT7V1 or RPICT4V3.
Package includes slave stand off for mounting onto master board.
RPICT4W3T1 - Raspberrypi AC current and voltage hat
Rating: Choose the maximum rms current in Ampere the board can support with the associated CT. For any custom setup please opt for "other".
Sensors and Raspberrypi are not included.
RPI_LCT8 400Aor more
8 CT ports
For any 5A output CT (in particular SCT-024 400A/5A)
RPI_LCT8 is similar to RPICT8 version 3 with screw terminal connectors for connecting larger CT sensors.
Unit comes ready for 400A CT using SCT-024/5A.
Documentation
Product Clearance. Last units being sold. We do not sell any 5A output CT any more and this should be...
Micro USB Extension cable with on / off switch for your convenience.
Just press the button to turn your Pi on and off. Avoid pulling the cable and save the connector lifetime.
Enclosure Kit for RPIZ_CT3T1
Package includes
2x 3D printed Parts (top and bottom part)
Can be mounted on DIN rail mounting support (not provided).
Note. 3D printed parts are fragile. Handle with care.
Colour might differ from picture. Enquire within to confirm colour.
