(for any other CT sensor please contact us to have adapted resistor mounted and calibration coefficients calculated)
Technical Specifications
Microcontroler
Atmel Attiny84
MCU Frequency
8Mhz
Operating Voltage
3.3V
Waveform Sampling
1250sps
Fastest Data Polling
600ms
Vertical Resolution
10 bits (1024 steps)
Communication
UART Serial Port
Firmware
Arduino (open source)
Dimensions
56x35mm
Programming port
6 pin ISP
Compatible OS
Any supporting GPIO serial port access
Compatible Raspberrypi
All of Family Raspberrypi Zero
Compatible CT
Current output type
AC Current Range
Options from 20A to 600A
AC Voltage Range
Options from 140V to 280V
Smallest Readable Current
Approx 50mA to 150mA
Scope of Use
This development board/kit is intended for use for ENGINEERING DEVELOPMENT, DEMONSTRATION, OR EVALUATION PURPOSES ONLY and is not considered by LeChacal.com to be a finished end-product fit for general consumer use. Persons handling the product(s) must have electronics training and observe good engineering practice standards. As such, the goods being provided are not intended to be complete in terms of required design-, marketing-, and/or manufacturing-related protective considerations, including product safety and environmental measures typically found in end products that incorporate such semiconductor components or circuit boards. This evaluation board/kit does not fall within the scope of the European Union directives regarding electromagnetic compatibility, restricted substances (RoHS), recycling (WEEE), FCC, CE or UL, and therefore may not meet the technical requirements of these directives or other related directives.
RPICT4V3 - Raspberrypi AC current and voltage hat
Rating: Choose the maximum rms current in Ampere the board can support with the associated CT. For any custom setup please opt for "other".
Voltage Sensor Type: Choose the desired support for the voltage port.
Sensors and Raspberrypi are not included.
RPI_LCT4V3 400A
4 CT port
3 Voltage port
400A capability
RPI_LCT4V3 is similar to RPICT4V3 with screw terminal connectors for connecting larger CT sensors.
Unit comes ready for 400A CT using SCT-024/5A.
Documentation
CONTACT US FIRST TO PURCHASE THIS PRODUCT.
WE RECOMMEND THIS PRODUCT BELOW INSTEAD FOR FIRST TIME USE:
RPICT7V1
RPIWA_CT7V1 - Raspberrypi AC current and voltage hat
Rating: Choose the maximum rms current in Ampere the board can support with the associated CT. For any custom setup please opt for "other".
Voltage Sensor Type: Choose the desired support for...
RPICT8 - Raspberrypi AC current hat
Rating: Choose the maximum rms current in Ampere the board can support with the associated CT. For any custom setup please opt for "other".
Sensors and Raspberrypi are not included.
Earlier version can be found here. RPICT8 Version 5.
Micro USB Extension cable with on / off switch for your convenience.
Just press the button to turn your Pi on and off. Avoid pulling the cable and save the connector lifetime.
Enclosure Kit for RPIZ_CT3V1
Package includes
2x 3D printed Parts (top and bottom part)
Can be mounted on DIN rail mounting support (not provided).
Note. 3D printed parts are fragile. Handle with care.
Colour might differ from picture. Enquire within to confirm colour.
