(for any other CT sensor please contact us to have adapted resistor mounted and calibration coefficients calculated)
Technical Specifications
Microcontroler
Atmel AVR32DB28
MCU Frequency
24Mhz
Operating Voltage
3.3V
Waveform Sampling
10ksps / 5.5Ksps
Fastest Data Polling
600ms
Vertical Resolution
12 bits (4096 steps)
Communication
UART Serial Port
Firmware
Arduino (open source)
Dimensions
56x35mm
Programming port
6 pin ISP
Compatible OS
Any supporting GPIO serial port access
Compatible Raspberrypi
All of Family 1,2,3,4 and Model A, B
Compatible CT
Current output type
AC Current Range
Options from 20A to 600A
AC Voltage Range
Options from 140V to 280V, 1500V
Smallest Readable Current
Approx 50mA to 150mA
Scope of Use
This development board/kit is intended for use for ENGINEERING DEVELOPMENT, DEMONSTRATION, OR EVALUATION PURPOSES ONLY and is not considered by LeChacal.com to be a finished end-product fit for general consumer use. Persons handling the product(s) must have electronics training and observe good engineering practice standards. As such, the goods being provided are not intended to be complete in terms of required design-, marketing-, and/or manufacturing-related protective considerations, including product safety and environmental measures typically found in end products that incorporate such semiconductor components or circuit boards. This evaluation board/kit does not fall within the scope of the European Union directives regarding electromagnetic compatibility, restricted substances (RoHS), recycling (WEEE), FCC, CE or UL, and therefore may not meet the technical requirements of these directives or other related directives.
OPICT8 - Orange Pi AC current hat
Rating: Choose the maximum rms current in Ampere the board can support with the associated CT. For any custom setup please opt for "other".
Sensors and Orange Pi are not included.
RPICT3T1 - Raspberrypi AC current hat with Temperature
Rating: Choose the maximum rms current in Ampere the board can support with the associated CT. For any custom setup please opt for "other".
Sensors and Raspberrypi are not included.
RPICT4V3 - Raspberrypi AC current and voltage hat
Rating: Choose the maximum rms current in Ampere the board can support with the associated CT. For any custom setup please opt for "other".
Voltage Sensor Type: Choose the desired support for the voltage port.
Sensors and Raspberrypi are not included.
Earlier version can be found here. RPICT4V3 VERSION 5.
Enclosure Kit for RPICT7V1 or RPICT3V1
Package includes
3x 3D printed Parts
4x M3 Screws
4x M3 Nuts
Note. 3D printed parts are fragile. Handle with care.
