Standalone Arduino Programmer (Mega Shield)
Standalone Arduino Programmer (Mega Shield)
Standalone Arduino Programmer (Mega Shield)
Standalone Arduino Programmer (Mega Shield)
Standalone Arduino Programmer (Mega Shield)
Standalone Arduino Programmer (Mega Shield)
Standalone Arduino Programmer (Mega Shield)
Standalone Arduino Programmer (Mega Shield)
Standalone Arduino Programmer (Mega Shield)
Standalone Arduino Programmer (Mega Shield)

Standalone Arduino Programmer (Mega Shield)

Standalone Arduino Programmer.

Flash arduinos without the need for a computer. Automate your production process.

SA_Programmer
In Stock
£13.50

 
Program your arduinos without the need of a computer.
* Only program the programmer once with Arduino IDE.
* Save the sketch to the SD card.
* Press the ok button.
* Green LED indicates successful flash.
  • This is a shield for the Arduino Mega (not included)
  • A micro SD card is required to operate (not included)
Package includes:
  • 1 Standalone programmer shield
  • 1 6pin ribbon cable.

The standalone Arduino Programmer can program many atmel chip in stand alone mode which means it does not need a computer to operate. This is very useful for automating the programming of large number of chips.

This product is a shield for the Arduino Mega.

You will need to program the Arduino Mega only once with a computer then the programmer will be stand-alone and only need connection with a power source.

The principle is:

  • Program the Arduino Mega with the sketch provided below.
  • Flash the target sketch on a SD card
  • Insert the SD card / Connect the mega to the power supply.
  • Connect the shield to the target device with the 6 pin cable.
  • Press OK on the shield.
  • Target is now programmed.

Features

  • Onboard Micro SD card.
  • 3 operation LED (work / ok / error).
  • 3 operation button.
  • 6 pin SPI connection to target.
  • Additional GPIO pins available for expansion.
  • Provision for use of a small LCD screen.

Usage

Preparing the programmer

  • Compile the target sketch on Arduino IDE.
  • Locate the produced hex file.
  • Copy it to the SD card.
  • Rename the file as 'firmware'hex'.
  • Insert the SD card in the programmer.

50 Items
No reviews
Product added to wishlist
Product added to compare.

Our webstore uses cookies to offer a better user experience and we recommend you to accept their use to fully enjoy your navigation.