Our webstore uses cookies to offer a better user experience and we recommend you to accept their use to fully enjoy your navigation.
WR703N Wireless Router OpenWRT / LEDE ready Upgraded to 16MB Memory flash (factory units are only 2MB). Suitable for larger application like Mesh. OpenVPN. Nodogsplash.
Interface board programming atmega328 arduino chip Compatible with Nanoprog and USBasp. * Burn bootloader. * Batch flash atmega328 chips. * Test chips before soldering.
Upload bootloader and arduino sketch to arduino compatible microcontroller. Documentation
PHILIPS Micro SDHC Card 16 GB Class 10 Ultra Speed UHS-1 80 MB/s Flashed with raspbian OS and configured ready to operate for use with RPICT series adaptors. Lite (no desktop) version provided by default. Please send us an email if you prefer the Desktop version. (note this is not Emoncms ready but only for serial output - python - linux)
Arduino Microcontroller flashed with requested sketch from customer.
Item:2.4G antenna Cable length: 15cm Antenna length: 11cm Interface: SMA; IPEX Frequency range: 2400-2500MHZ Gain: 2dbi Standing wave ratio: Less than or equal to 1 Input impedance:50ohm Maximum power:50W
NanoFlashProg - Programmer for SPI Flash chip using Arduino Nano. Currently supported chips are Winbond. Shield Only Package is the shield alone without arduino/clamp. Full Package includes: * 1 NanoFlashProg shield * 1 Arduino Nano * 1 SOIC8 clamp with cable. Documentation link
Breakout Board for the Hanrun HR9111 Pin out ready to connect to SKW71 module. Pinout: Gnd 2V TX- TX+ RX- RX+