RPICT4V3 Version 3

Neuf

Connect up to 4 Current and 3 voltage sensors to a raspberrypi.

Rating: Choose the maximum rms current in Ampere the board can support with the associated CT. For any custom setup please opt for "other".

Plus de détails

331 Produits

£ 19.00

-£ 16.00

£ 35.00

En savoir plus

 

 
 

RPICT4V3 Version 3

Raspberrypi AC current and voltage hat



Online Documentation


  • 4x AC Current Ports.
  • 3x AC Voltage Ports.
  • Provides Irms, Vrms, RealP, ApparentP, ReactiveP, PFactor, EstimatedP.
  • View/record data using Linux / Python / Emoncms / Grafana / MQTT and more.
  • Configurable from serial port.
  • Power combinations configurable (Current-Voltage pairing).
  • Open Source Arduino Firmware.
  • Stackable with RPICT8 RPICT7V1 RPICT4V3

Package Content

  • 1 RPICT4V3 Unit.
  • 4 Mounting Stand off with screws.
The listing does not include sensors and Raspberrypi.

Recommended Sensors

Voltage:

Current:

(for any other CT sensor please contact us to have adapted resistor mounted and calibration coefficients calculated)

Technical Specifications

Microcontroler Atmel Atmega328p
MCU Frequency 16Mhz
Operating Voltage 3.3V
Waveform Sampling 3333sps
Fastest Data Polling 800ms (for 4 channels)
Vertical Resolution 12 bits (4096 steps)
Communication UART Serial Port
Firmware Arduino (open source)
Dimensions 56x65mm
Programming port 6 pin ISP
Compatible OS Any supporting GPIO serial port access
Compatible Raspberrypi All of Family 1,2,3,4 and Model A, B
Compatible CT Current output type
AC Current Range Options from 20A to 600A
AC Voltage Range Options from 140V to 280V
Smallest Readable Current Approx 50mA to 150mA

Stacking boards

IMG_0980_small.png
  The RPICT4V3 version 3 can be stacked with other RPICT7V1 or RPICT4V3 or RPICT8 to expand the numbers of sensors supported.  See more about stacking in the link below. Stacking Documentation

Scope of Use

This development board/kit is intended for use for ENGINEERING DEVELOPMENT, DEMONSTRATION, OR EVALUATION PURPOSES ONLY and is not considered by LeChacal.com to be a finished end-product fit for general consumer use. Persons handling the product(s) must have electronics training and observe good engineering practice standards. As such, the goods being provided are not intended to be complete in terms of required design-, marketing-, and/or manufacturing-related protective considerations, including product safety and environmental measures typically found in end products that incorporate such semiconductor components or circuit boards. This
evaluation board/kit does not fall within the scope of the European Union directives regarding electromagnetic compatibility, restricted substances (RoHS), recycling (WEEE), FCC, CE or UL, and therefore may not meet the technical requirements of these directives or other related directives.

 

Avis

Aucun avis n'a été publié pour le moment.

Donnez votre avis

RPICT4V3 Version 3

RPICT4V3 Version 3

Connect up to 4 Current and 3 voltage sensors to a raspberrypi.

Rating: Choose the maximum rms current in Ampere the board can support with the associated CT. For any custom setup please opt for "other".

Accessoires