RPICT4V3 Version 3

New product

Connect up to 4 Current and 3 voltage sensors to a raspberrypi.

Rating: Choose the maximum rms current in Ampere the board can support with the associated CT. For any custom setup please opt for "other".

Master Kit:
Contain one RPICT board with 4 master stand off and microcontroller included.
Slave Kit:
Contain one RPICT board with 4 slave stand off without microcontroller.

More details

972 Items

£ 29.00

-£ 6.00

£ 35.00

  • Master Kit
  • Slave Kit

Add to wishlist

More info



RPICT4V3 version 3 - Raspberrypi CT Adaptor


IMG_1241_small.pngConnect 4 Current and 3 voltage sensors to a Raspberrypi



Documentation


  • 4x Current sensor ports
  • 3x ac Voltage sensor ports
  • Arduino IDE programmable
  • Output Active Power/ Apparent power/ Power Factor/ Irms/ Vrms
  • Text based serial output.
  • Atmega328p Microcontroller
  • View/record data using Linux/Python/Emoncms/Nodered/Grafana
  • Stackable - Up to 5 board stack on one Raspberrypi.
  • Compatible with Raspberrypi 2 & 3 & 4.


Package Content

  • 1 RPICT4V3 version 2 Unit.
  • 4 Mounting Stand off.
  • 8 Mounting Screws.
Note: Raspberrypi and sensors are not included in this listing.

Recommended Sensors

  • Voltage: 77DB-06-09 77DE-06-09 77DA-10-09 CT3957-NA
  • Current: SCT-013-000 SCT-019 SCT-006 or any other current output CT.

Rating

The "Rating" option determines the maximum reading the board can do. the lower the rating the higher the resolution.  If you need different rating per channel choose rating "other" and email us the details of each single channels.


Default Parameters:

* Node ID: 11

* Scan interval: 5 seconds

* Output: Space separated Values (Emonhub)


Default loaded sketch freely available on the wiki page.





Stacking boards

IMG_0980_small.png
  The RPICT4V3 version 3 can be stacked with other RPICT7V1 or RPICT4V3 or RPICT8 to expand the numbers of sensors supported.  See more about stacking in the link below. Stacking Documentation


This development board/kit is intended for use for ENGINEERING DEVELOPMENT, DEMONSTRATION, OR EVALUATION PURPOSES ONLY and is not considered by LeChacal.com to be a finished end-product fit for general consumer use. Persons handling the product(s) must have electronics training and observe good engineering practice standards. As such, the goods being provided are not intended to be complete in terms of required design-, marketing-, and/or manufacturing-related protective considerations, including product safety and environmental measures typically found in end products that incorporate such semiconductor components or circuit boards. This evaluation board/kit does not fall within the scope of the European Union directives regarding  electromagnetic compatibility, restricted substances (RoHS), recycling (WEEE), FCC, CE or UL, and therefore may not meet the technical requirements of these directives or other related directives.

Reviews

No customer reviews for the moment.

Write a review

RPICT4V3 Version 3

RPICT4V3 Version 3

Connect up to 4 Current and 3 voltage sensors to a raspberrypi.

Rating: Choose the maximum rms current in Ampere the board can support with the associated CT. For any custom setup please opt for "other".

Master Kit:
Contain one RPICT board with 4 master stand off and microcontroller included.
Slave Kit:
Contain one RPICT board with 4 slave stand off without microcontroller.

Accessories